In this video, we demonstrate how the Untwist Tool helps untwist and straighten Ethernet wires quickly and efficiently. Whether you're working with CAT5e, CAT6, or crossover cables, this tool can save time and reduce frustration when prepping patch cables for jacks.
If you've ever built your own Ethernet cables, you know the most tedious part is untwisting the four wire pairs and aligning the eight wires in the correct order. This tool aims to make that process easier and faster.
Overall, if you're making lots of Ethernet cables, this tool can seriously cut down on time and frustration. If you're new to it, give it a few tries—you’ll get the hang of it quickly. Full video demo is available above.
Hi everyone and welcome back! I'm Mike, and this is the Ultimate Tech Hub. If you've followed our channel, you’ve probably seen our videos on how to make Cat 5e cables, Cat 6 cables, and even crossover cables. If not, be sure to check those out.
One of the hardest parts of making patch cables is untwisting the twisted pair wires and getting all eight wires perfectly straight. So the big question is—can this be done faster and easier?
We may have found the solution: the Untwist Tool, created by a company of the same name. This tool is specifically designed to untwist all four pairs and help straighten the wires afterward. The company sent us one for review.
The basic Untwist Tool costs $18.99. They also sell a combo pack with a cordless electric screwdriver and several attachments for $46.99. If you purchase just the basic version, you’ll need to use your own cordless drill.
To use it, strip the Ethernet cable to expose the four twisted pairs. Separate the pairs and insert one pair at a time into the tool. Make sure your drill is set to reverse—otherwise, it will twist the wires even more. Use the lowest speed possible, run the tool to the end of the wire, then remove the pair. Repeat for each pair.
After all wires are untwisted, straighten them by dragging them over the plastic wheel with light pressure several times. This will leave the wires flat and ready for insertion into the jack.
Note that using a standard drill can be tricky. If it spins too fast, the wires can get messy. It took me about four tries to really get the hang of it. I wish the company had sent the combo pack because the included electric screwdriver would probably make things a lot easier.
Still, the tool does exactly what it’s supposed to do. It works great—but expect a short learning curve while you get used to it.
So, to answer the original question: is there a faster way to untwist and straighten Ethernet wires? Yes—this tool makes the job much easier. I definitely recommend it, especially the combo set.
You’ll find a purchase link in the video description. Also, check out our Patreon page. For just $2/month, you can help support the channel, and every new member gets a personal shoutout in our next video.
If you found this helpful, please give it a thumbs up and share it. And if you love it, hit subscribe to keep our channel going. Thanks for watching!
On today\'s episode we will show you how to install a 2-port Cat6 Network Faceplate and a Low Voltage Gang Bracket. We will ...
Master RJ45 Crimping Pro Tips for Perfect Cables! Have you ever wondered which RJ45 Connector you should use? Ethernet ...
STOP Buying CAT7 Ethernet! In this video I will test a Cat 7 Ethernet Cable from China to see if its actually Cat7! Testing Cat 7 ...
On today\'s episode we show you how to test CAT5e, CAT6, & CAT6A Ethernet cables. And we will also show you how to map an ...
Get Faster Internet Speeds When You Change 1 Thing! On today\'s episode we will install Cat7 into our Home Network to see if we ...
STOP Buying CAT7 Ethernet! In this video I will test 5 different Cat 7 Ethernet Cables to see which ones are actually Cat7!